Grigori SystemsMonitor · Analyse · Protect

← Grigori calculators · Trial version

Engineering tools / Fluid reliability

Grigori Dirt Mass & Throughput Calculator

Diesel and oil calculations in one place. Enter actual operating values to see litres, grams and kilograms.

Works offline. Save an assessment copy to keep your entries. The example is illustrative, not a measured customer result.

01Diesel — fuel consumed and dirt carried

Select a range code. Chart-based mass is indicative only.

Enter fuel burned by the engine, excluding fuel returned to the tank. A nameplate or estimated burn rate gives a scenario estimate; actual burn varies with duty and load.
Fuel consumed (L)—
Dirt carried per hour (g/hour)—
Dirt in consumed fuel (g)—
Dirt in consumed fuel (kg)—

Fuel consumed = L/hour × running hours.
Dirt (g) = concentration (g/L) × fuel consumed (L).

This is dirt associated with the consumed fuel volume at the selected concentration. It is not necessarily dirt reaching the injectors; downstream filtration and the sampling point matter.
Diesel common-rail injector and high-pressure fuel pump clearances and contamination damage

Select the image to open the full-size technical view.

Why cleanliness matters: critical injector and pump clearances are only 1–5 µm. Typical dust, silt, wear particles and water droplets can be many times larger, causing scoring, sticking, internal leakage, reduced pressure and poor fuel atomisation.

Contaminant sizes (approximate)
  • Dust particle: 5–40 µm
  • Silt: 10–50 µm
  • Wear particle: 10–100 µm
  • Water droplet: >10 µm

Many contaminants are 10–100× larger than the critical clearances.

Open full-size infographic

02Oil — tank contents and pump circulation

Select the oil range code and ISO channel, and enter the tank volume once. Add pump flow and running time to calculate circulation through the same system.

Dirt contained in the tank

Select a range code. Chart-based mass is indicative only.

These oil inputs are shared with the pump circulation calculation below.
Dirt in oil (g)—
Dirt in oil (kg)—

Dirt in tank (g) = concentration (g/L) × actual oil volume (L).
Kilograms = grams ÷ 1,000.

Assumes representative, uniform concentration. Settled sludge is not included unless represented in the sample used for the selected range code.

Volume and dirt circulating through the pump

Uses the oil volume and selected ISO range code above.

Recirculation counts repeated passages of the same dirt. The cumulative mass below is not additional dirt in the tank or dirt removed by a filter. Filter capture requires separate evidence.

Use actual flow where available. Pump rated flow is an assumption. Exclude stopped time. The calculation assumes constant flow and concentration; filtration may reduce concentration during operation.
Oil circulated (L)—
Nominal tank turnovers—
Cumulative dirt passage (g)—
Cumulative dirt passage (kg)—

Oil circulated = L/min × hours × 60.
Turnovers = circulated litres ÷ tank litres.
Cumulative passage (kg) = concentration (g/L) × circulated litres ÷ 1,000.

Precision clearances in motion: hydraulic servo valve, gear tooth contact and rolling-element bearing under moderate radial load